博文
Caterpillar 311F LRR - JFT Crawler Excavator Pump Removal and Installation
||
This article Caterpillar 311F LRR - JFT Crawler Excavator Pump Removal and Installation
Removing steps
Caterpillar 18 Digits Factory Password Calculator One-Time Calculate Service
begin:
A . Remove the alternator belt. See Disassembly and Assembly, "Alternator belt-Removing and installing" for the correct steps.
pay attention to
Keep all the parts clean without impurities.
Impurities can cause rapid wear and shorten component life.
pay attention to
When
inspecting, maintaining, testing, adjusting and repairing products, be
careful to ensure that the liquid is held in the container. Before
opening any chamber or disassembling any part with stored storage.
Dispose of all liquids in accordance with local regulations and instructions.
CAT Caterpillar ET 3 Diagnostic Adapter 317-7485/478-0235 Diagnostic Tool-high quality
2. Remove the bolts (1) from the water pump (2).
3. Remove the water pump (2) from the cylinder block.
4. Remove the seal (3).
Installation steps
pay attention to
Keep all the parts clean without impurities.
Impurities can cause rapid wear and shorten component life.
1.
Ensure that the water pump is clean and free from wear and damage.
Replace the water pump , if necessary. Clean the sealing surface of the
water pump.
Caterpillar ET 2024A & 2023C & 2019C Electronic Technician Diagnostic Software Download and Installation
2. Clean the sealing surface on the cylinder block.
3. Install the new seal (3) on the water pump (2).
4. Install the water pump (2 ) on the cylinder block.
Note: Make sure that the water pump is facing correctly.
5. Install the bolts (1) to the water pump. Tighten the bolts to a torque of 25 Nm (221 lb in).
6. Fill the coolant to the cooling system. Refer to the Operation and Maintenance Manual, "Cooling System Coolant-Replace" for the correct steps.
End By: Install the alternator belt. See Disassembly and Assembly, "Alternatator belt Removing and Installation" for correct steps.
免责声明：本文中使用的图片均由博主自行发布，与本网无关，如有侵权，请联系博主进行删除。
下一篇: Caterpillar 311F LRR - JFT Crawler Excavator Engine Oil Cooler Installation
全部作者的其他最新博文
- • the hydraulic release of the single hydraulic circuit of the caterpillar311D LRR
- • JCB Backhoe Loader Power Shift - Chain Adjustment
- • Perkins 2806F Engine Inlet and Exhaust Valve Springs - Remove and Install
- • Caterpillar 312D2 and 313D2 Excavator 3054C Engine System Pressure- -Release
- • Parking Brake Lining Clearance and Lever Travel Adjustment on Isuzu Vehicles
- • Doosan DA30 Dump Truck the ECU Wiring Tier2 -Removal
