切换至摄影模板
博文
Cummins M11 Series Engine oil Pan and Oil Pipe Removal Guide
|
This short article introduces how to disassemble the oil pan and oil pipe of Cummins M11 series engine
① Rotate the engine on the engine overhaul stand so that its side faces upward. Remove the two screws at positions 1 and 2 in Figure 2-88. 3 bolts, install the guide pin, and then remove the remaining 32 oil pan bolts.
② Remove the oil delivery pipe on the rear oil sump type oil pan, see Figure 2-89, and discard the two O-rings.
③ If the engine is equipped with a front oil collection tank suction pipe, remove it from the cylinder block, see Figure 2-90, and discard the O-ring.
Cummings INLINE 6 Diagnostic Adapter for Heavy Duty Truck High Quality
免责声明：本文中使用的图片均由博主自行发布，与本网无关，如有侵权，请联系博主进行删除。
上一篇:
How to Ignite the Fuel System Assisted Start of DoosanDX340LC Crawler Excavator
下一篇: DoosanDX340LC Crawler Excavator Fuel Tank Removal Guide
下一篇: DoosanDX340LC Crawler Excavator Fuel Tank Removal Guide
全部作者的其他最新博文
- • the hydraulic release of the single hydraulic circuit of the caterpillar311D LRR
- • JCB Backhoe Loader Power Shift - Chain Adjustment
- • Perkins 2806F Engine Inlet and Exhaust Valve Springs - Remove and Install
- • Caterpillar 312D2 and 313D2 Excavator 3054C Engine System Pressure- -Release
- • Parking Brake Lining Clearance and Lever Travel Adjustment on Isuzu Vehicles
- • Doosan DA30 Dump Truck the ECU Wiring Tier2 -Removal
