切换至摄影模板
博文
How to deal with the problem that the oil-water Separator Alarm Keeps Popping Up
|
This
article mainly introduces how to deal with the problem that the
oil-water separator alarm keeps popping up after the DX215-9C Doosan
Construction Machinery model is powered on, the engine accelerates
normally, and the buzzer keeps sounding.
https://www.heavydutydiag.com
Inspection Method:
1) Check that the oil-water separator filter element is not clogged, and the fault persists after draining
the water;
2) The fault will disappear intermittently due to vibration during driving;
3) Check the voltage of the water level sensor and find that when there is a fault, the sensor S terminal
0.85YB line has always been an abnormal ground signal. This terminal should be 3.0-3.8V when there
is no water;
4) The fault persists after unplugging the sensor plug, so it is judged that the alarm should be caused by a circuit fault.
Repair results:
After removing the rear cover of the cab, it was found that there was obvious
interference and wear between the EPOS wire harness and the EPOS bracket, which caused the CN1-38
terminal to be broken and ironed. The fault disappeared after the wire harness was re-bandaged.
免责声明：本文中使用的图片均由博主自行发布，与本网无关，如有侵权，请联系博主进行删除。
上一篇:
How to Remove the Cummins M11 Series Engine Hydraulic Pump, Sensor Wiring Harnes
下一篇: How to Disassemble the Rotary Reduction Device of Caterpillar 325, 320L, 320N, a
下一篇: How to Disassemble the Rotary Reduction Device of Caterpillar 325, 320L, 320N, a
全部作者的其他最新博文
- • the hydraulic release of the single hydraulic circuit of the caterpillar311D LRR
- • JCB Backhoe Loader Power Shift - Chain Adjustment
- • Perkins 2806F Engine Inlet and Exhaust Valve Springs - Remove and Install
- • Caterpillar 312D2 and 313D2 Excavator 3054C Engine System Pressure- -Release
- • Parking Brake Lining Clearance and Lever Travel Adjustment on Isuzu Vehicles
- • Doosan DA30 Dump Truck the ECU Wiring Tier2 -Removal
