This article explains how to remove a Volvo excavator adjuster

Vovol Penta EPC 6 Offline 04.2023 Industrial Engines Download and Installation

   a. Thoroughly clean the oil pump before removing the regulator.  

 b. Make a mark on the regulator that is symmetrical to the pump.

  c. Choose a clean workbench. 

 d. Be careful not to mix the front and rear pump regulator parts.  

 f. It is recommended to replace the entire regulator assembly because it includes small precision-machined parts and is very difficult to dismantle and repair. Disassembly of the regulator is as follows.

How to remove a Volvo excavator adjuster This article explains how to remove a Volvo excavator adjuster a. Thoroughly clean the oil pump before removing the regulator. b. Make a mark on the regulator that is symmetrical to the pump. c. Choose a clean workbench. d. Be careful not to mix the front and rear pump regulator parts. 1 e. There is no need to disassemble or loosen the screws for cleaning. f. It is recommended to replace the entire regulator assembly because it includes small precision-machined parts and is very difficult to dismantle and repair. Disassembly of the regulator is as follows.   

 11.2021 Vovol Impact 9227 EPC+ Service Repair Offline Download & Installation Service

① Spread a rubber mat on the workbench to prevent components from being bruised.

  ② Use detergent to remove dust, rust, etc. on the surface of the regulator. 

 ③ Remove the screws (412, 413) and remove the regulator, paying attention at the same time. shaped sealing ring, as shown in Figure 4-129.

  ④ Remove the screws (438) and remove the cover (629), which is equipped with the adjusting screws (628, 925) and the adjusting ring. (627), locking nut (630), screw (801) and adjusting screw (924) (do not loosen these screws and nuts), as shown in Figure 4-130. 

 ⑤After removing the cover (629) assembly, take out the outer spring (625), inner spring (626) and spring seat (624) from the compensation part, and then pull out the adjustment ring (645) and servo hydraulic spring (646) from the servo hydraulic part. ) and spring seat (644). Figure 4-131 The adjusting ring (645) can be pulled out with an M4 screw.  

⑥ Remove the screws (436, 438) and remove the servo hydraulic cover. After removing the servo hydraulic cover, take out the adjusting spring (655) from the servo hydraulic part, as shown in Figure 4-132. 

12.2023 VovoL PROSIS Offline R4 EPC+Service Repair Manual Installation
⑦ Remove the snap ring (814), and take out the outer spring seat (653), rebound spring (654) and sleeve (651). As shown in Figure 4-133, the sleeve (651) is equipped with a snap ring (836) .  

⑧ Remove the snap ring (858), and take out the outer strut plug (614) and adjustment plug (615). The strut plug (614) and adjustment plug (615) can be removed with an M6 screw, as shown in Figure 4-134

  ⑩ Use a thin steel rod to push out the pin (874) (diameter 4mm) so that it does not block the rod (612), as shown in Figure 4-136. 

 ⑪ Remove the feedback rod (611) and record the direction of the rod, as shown in Figure 4-137. 12 Remove the feedback rod (612) without pulling out the pin (875). 5 3 Pull out the servo hydraulic piston (643) and the spool (652). ⑩Pull out the piston box (622) and compensation piston (621) and compensation rod (623).

⑭Pull out the piston box (622) and compensation piston (621) and compensation rod (623).