博文

How to Solve the Problem of no Movement of Doosan Excavator

已有 395 次阅读2024-2-1 09:27 |系统分类:科技教育分享到微信

This article introduces how to solve the problem of no movement of Doosan excavator.

Note: All models (except S55-V)

After the engine is started, press the safety lever on the left console and operate the left and right handles. The whole vehicle will not move.

1. Checking essentials

a. Check that 6# fuse is not burned out, it is normal.

b. When it is infinity, it is normal when it is closed and it is 0.

c resistance is 13.5 ohms normal.

d. Check that the valve core of the work cut-off solenoid valve is functioning normally. After e was

disassembled, it was found that the spring in the relief valve was broken.

2. Reason:

The spring in the relief valve is broken, causing the pilot pressure to be too low, unable to push the valve

core to move, and the entire vehicle does not move.

3. Treatment method: Replace the spring and clean it.

免责声明：本文中使用的图片均由博主自行发布，与本网无关，如有侵权，请联系博主进行删除。

上一篇: How to Remove a Volvo Excavator Adjuster
下一篇: How to Disassemble the Swing motor of Caterpillar 325, 320L, 320N, 320S Excavato