博文

How to Solve the Problem of Black Smoke From the Doosan Excavator X120 Engine

已有 248 次阅读2024-1-24 21:22 |系统分类:科技教育分享到微信

This article mainly introduces how to solve the problem of black smoke from the Doosan excavator X120 engine.

Fault description

1. The engine has obvious black smoke when under heavy load. 2. There

are no alarms or fault codes on the instrument panel

Failure cause analysis

1. Check whether the air filter element, oil-water separator, and fuel

fine filter have exceeded the maintenance period or are dirty and need to be maintained in

advance.

2. Since there is no fault code, it is basically judged to be a mechanical failure, and

the cylinder cutoff test is carried out by cutting off the oil (a special high-pressure common

rail plug is required)

3. When the fuel injector of the 2nd cylinder is cut off, the black

smoke is significantly reduced, so it can be judged that the 2nd cylinder injector is faulty.

4. After replacing the 2-cylinder injector, the equipment operates normally.

Doosan Diagnostic Tool UVIM Support Doosan Excavators High Quality

in conclusion

1. Due to the abnormal wear of the 2-cylinder injector, the fuel injection volume becomes

larger, the atomization is poor, the combustion is insufficient, and the engine emits black smoke.

Doosan Diagnostic Tool DDT G2 SCAN( ECU ,DCU)Software 2016

免责声明：本文中使用的图片均由博主自行发布，与本网无关，如有侵权，请联系博主进行删除。

上一篇: How to Introduce the Disassembly and Installation of Isuzu Excavator Electronic
下一篇: How to Test the Air in The Fuel of a Caterpillar 325C Excavator