博文

How to Remove Cummins M11 Engine thermostat, Torque converter cooling plate, oil

已有 376 次阅读2024-1-21 07:37 |系统分类:科技教育分享到微信

This article mainly introduces how to remove the Cummins M11 engine thermostat, torque converter cooling

plate, oil cooler and oil filter

① Loosen the coolant hose clamp, and remove the 4 bolts, thermostat housing and thermostat, see

Figure 2-28.

② The torque converter cooling plate restricts the flow of coolant through the thermostat housing to the

water pump bypass hose. This allows the coolant to circulate through the remotely mounted torque

converter oil cooler. Remove the torque converter cooling plate between the thermostat housing and

the

water pump bypass hose joint, see Figure 2-29.

③ Remove the 4 bolts between the oil cooler and the thermostat housing bracket flange, and remove

the

4 bolts between the oil cooler and the oil filter seat, the oil cooler and the sealing gasket, see Figure 2

-30, and remove the oil cooler water inlet pipe, water outlet pipe and mounting flange.

④ Remove the Jacobs@ engine brake oil supply pipe, and remove the turbocharger oil return pipe bracket mounting bolts, see Figure 2-31

CUMMINGS INPOWER PRO 14.5 Diagnostic Software with 2023.6 PGA by remote installation

⑤ Remove 9 bolts, oil filter seat and sealing gasket, see Figure 2-32. Remove the supercharger oil return pipe from the cylinder block.

免责声明：本文中使用的图片均由博主自行发布，与本网无关，如有侵权，请联系博主进行删除。

上一篇: How to Solve the Problem of Doosan Excavator DX120 Automatically Shutting Down a
下一篇: How to Solve the Problem of Intermittent Alarm and Speed limit of 1400RPM When t