博文

How to Disassemble the Exhaust Manifold and Intake Manifold of Cummins M11 Serie

已有 380 次阅读2024-1-14 04:23 |系统分类:科技教育分享到微信

This Article explains how to disassemble the exhaust manifold and intake manifold of a Cummins M11 series engine.

① The exhaust manifold assembly consists of three sections. When disassembling, remove a bolt from

the end of each section and then install two guide pins. (Part No. 3376488), remove the remaining bolts,

and then remove the exhaust manifold, see Figure 2-25.

② Remove the intake manifold pressure sensor and temperature sensor wire connectors from the

intake manifold, see Figure 2-26.

③ Remove the intake manifold joint and gasket from the top of the intake manifold, remove the two

mounting bolts, and install the two guide pins (Part No. 3376488), remove the remaining bolts, and

install the lifting frame to the rocker arm chamber shell with 4 M10 × 25 bolts. The tightening torque is

47N·m, see Figure 2-27.

免责声明：本文中使用的图片均由博主自行发布，与本网无关，如有侵权，请联系博主进行删除。

上一篇: How to Deal with the Alarm and Speed limit of 1400RPM when the Doosan Excavator
下一篇: How to Troubleshoot Excessive Black Smoke on a Caterpillar 325c Excavator