切换至摄影模板
博文
How to Remove Cummins M11 Turbocharger and Oil Return Pipe
|
This article mainly introduces how to disassemble the Cummins M11 turbocharger and the oil return pipe.
① Remove the oil supply pipe and sealing gasket from the top of the turbocharger, remove the other end
of the oil supply pipe from the oil filter seat, and then remove the oil return pipe and sealing gasket from
the bottom of the turbocharger, see Figure 2-22.
② Remove the V-shaped clamp, exhaust elbow and O-ring from the exhaust port of the turbocharger
compressor, remove 4 mounting nuts, remove the turbocharger and gasket, and block the supercharger
For
the oil supply hole and oil return hole, see Figure 2-23.
③ Remove the turbocharger oil return pipe joint, see Figure 2-24.
免责声明：本文中使用的图片均由博主自行发布，与本网无关，如有侵权，请联系博主进行删除。
上一篇:
How to Solve the Problem that the Engine of Caterpillar 325C Excavator Cannot be
下一篇: How to Solve the Walking Failure of Doosan DH220-V Excavator
下一篇: How to Solve the Walking Failure of Doosan DH220-V Excavator
全部作者的其他最新博文
- • the hydraulic release of the single hydraulic circuit of the caterpillar311D LRR
- • JCB Backhoe Loader Power Shift - Chain Adjustment
- • Perkins 2806F Engine Inlet and Exhaust Valve Springs - Remove and Install
- • Caterpillar 312D2 and 313D2 Excavator 3054C Engine System Pressure- -Release
- • Parking Brake Lining Clearance and Lever Travel Adjustment on Isuzu Vehicles
- • Doosan DA30 Dump Truck the ECU Wiring Tier2 -Removal
