博文

This article explains how to add engine coolant to the radiator

已有 339 次阅读2023-12-25 04:29 |系统分类:科技教育分享到微信

The steps below to add coolant to the radiator and sub-tank. This step is the first time you add coolant to

the water tank or add it again after the water in the water tank is drained. The picture below shows an

ordinary water tank.

Doosan Diagnostic Tool UVIM Support Doosan Excavators High Quality

1. Check to confirm that the drain plug or drain faucet of the water tank (Figure 5, (1)) is installed and

tightened. At the same time, confirm that the coolant drain plug of the cylinder block (Figure 4-6, (1))

tightly closed or the antifreeze pipe has been installed.

2. Turn counterclockwise 1/3 turn to remove the water tank cover (Figure 7, (2)).

2020 Doosan Daewoo Excavator Operation and Repair Manual PDF

3. Slowly add engine antifreeze into the water tank until the liquid level is level with the water filling

port. Make sure no bubbles form when adding.

4. Tighten the water tank cover (Figure 7, (2)). Align the mark on the back of the tank cover with the

notch on the edge of the addition port. Press down on the water tank cap and turn it 1/3 turn clockwise.

5. Remove the water tank cover (Figure 7, (3)) and add engine antifreeze to the lower limit (cold)

position (Figure 7, (4)). Put the lid back on.

6. Check the pipe connecting the water tank (Figure 7, (5)) and the radiator (Figure 7, (3)). Make sure

it is well connected and not pinched or damaged. If the pipe leaks, the antifreeze will also leak and not

flow to the radiator tank

. 7. Start the engine until it reaches operating temperature. Check the coolant level in the auxiliary tank

While the engine is running, check the antifreeze level. When the engine coolant is at normal

temperature, the coolant level in the auxiliary tank should be at or close to the full (hot) position.

(Figure 7, (6)). If it is not in this position, add coolant to the auxiliary water tank until it is full.

免责声明：本文中使用的图片均由博主自行发布，与本网无关，如有侵权，请联系博主进行删除。

上一篇: How to Solve the Excessive Black Smoke Problem of Caterpillar 325C Excavator
下一篇: How to Solve the Problem of Caterpillar 325C Excavator Engine not Igniting, not