切换至摄影模板
博文
How to troubleshoot the problem of caterpillar engine starter not running
caterpillar 320A engine starter not running Possible causes and troubleshooting methods are as follows.
the battery. https://www.heavydutydiag.com/product/caterpillar-et-2022a-electronic-technician-diagnostic-software/
(1) The battery output voltage is low. Check the condition of the battery. If necessary, recharge or replace
(2) Wire or switch failure. Repair wires or switches. If necessary, replace wires or switches.
(3) The starter solenoid coil is faulty. Install new starter solenoid.
(4) Starter failure. Repair or replace starter.
CAT Caterpillar ET 4 Diagnostic Adapter Truck Diagnostic Tool
免责声明：本文中使用的图片均由博主自行发布，与本网无关，如有侵权，请联系博主进行删除。
上一篇:
How to Remove and Install Isuzu Excavator Fuel Injector
下一篇: Fault Diagnosis and Maintenance of Carter 320A Excavator's Slow Movement and Wea
下一篇: Fault Diagnosis and Maintenance of Carter 320A Excavator's Slow Movement and Wea
全部作者的其他最新博文
- • the hydraulic release of the single hydraulic circuit of the caterpillar311D LRR
- • JCB Backhoe Loader Power Shift - Chain Adjustment
- • Perkins 2806F Engine Inlet and Exhaust Valve Springs - Remove and Install
- • Caterpillar 312D2 and 313D2 Excavator 3054C Engine System Pressure- -Release
- • Parking Brake Lining Clearance and Lever Travel Adjustment on Isuzu Vehicles
- • Doosan DA30 Dump Truck the ECU Wiring Tier2 -Removal
