Installation of Injection Pump of New Holland_b115 Engine
STEP 1

2023 CASE New Holland Electronic Service Tools (CNH EST v9.7Up3) Engineering Diagnostic Software

Replace gasket on pump mounting flange.

STEP 2

Install pump and tighten the three mounting nuts.

STEP3

STEP4

Apply Loctite 5205 to the surface of the cover plate,
install cover plate and mounting bolts, tighten bolts.

STEP 5

Connect wire to temperature sensor.

STEP 6

Connect the fuel feed line to the injector pump.
SECTION 10 - ENGINE - CHAPTER 1 7
Issued 12-04

STEP 7

Remove covers from lines and fittings. Connect fuel
injector lines (1), connect fuel return line (2), and
boost line (3) to the pump. 

STEP 8

CNH DPA5 Adapter New Holland Heavy Duty mechanical Diagnostic Tool


Install oil filler tube (3), mechanical fuel pump (2),
and fuel filter (1) on the engine.

STEP 9

Install the injector line retaining bracket mounting
bolts.

STEP 10

Loosen injector pump locking bolt and install the
slotted plate, tighten the locking bolt to 9 to 10 lb-ft
(12 to 14 Nm).

STEP 11

Make sure locking pin is disengaged from gear.

STEP 12
Remove the engine turning tool and install the
starter.

STEP 13

If the machine has only one battery, connect the
negative battery cable to the battery. Install the
battery cover.

STEP 14

Install grounding cable (2) onto the terminal. Install
the jumper cable (3) on the terminal and start the
terminal nut (1) onto the terminal. Tighten the
terminal nut.

STEP 15

Install the front rocker arm cover and injector line
retaining bracket mounting bolt.

STEP 16

Install the throttle cable into the bracket and tighten
the jam nut.

STEP 17

Install and thighten the two throttle arm mounting
bolts.

STEP 18

New Holland AG& CE Service Manuals PDF 2019Download (170GB)

Connect the power lead to the injector pump.