博文
Bobcat STEERING LEVERS Removal and Installation Guide
Removal and Installation guide
2022 Bobcat Service Analyzer Diagnostic Software 90.00
NOTE: Early production machines used 3-piece assembly.
Current production machines use 1-piece shield which
must be removed as a unit.
Remove the front panel
Remove the bolts and remove both side shields 00.
Remove the bolts from the steering lever shield (g & [Q].
Remove the steering linkage at the steering levers
Disconnect the auxiliary linkage from the right steering lever
lID
Remove the bolts (Item 1) from the pivot bearings 'Cl.
Installation: Tighten the bolts to 25-28 ft.-Ibs. (34-38 Nm)
torque.
2022 Bobcat Service Analyzer Diagnostic Software 90.00
Remove the steering lever assembly @.
Repairing the Steering Levers
Remove the rubber bushing and the Teflon bushing from the
steering levers.
Install the new rubber bushings into the steering levers using
two sockets and a vise ~l
2022 Bobcat Service Analyzer Diagnostic Software 90.00
Install the Teflon bushings on the steering levers [!!).
Install the two steering lever assemblies together ~.
Check the pivot bearings and replace as needed.
免责声明：本文中使用的图片均由博主自行发布，与本网无关，如有侵权，请联系博主进行删除。
下一篇: JCB Excavator 3CX 4CX Changing the Oil and Filter Guide
全部作者的其他最新博文
- • the hydraulic release of the single hydraulic circuit of the caterpillar311D LRR
- • JCB Backhoe Loader Power Shift - Chain Adjustment
- • Perkins 2806F Engine Inlet and Exhaust Valve Springs - Remove and Install
- • Caterpillar 312D2 and 313D2 Excavator 3054C Engine System Pressure- -Release
- • Parking Brake Lining Clearance and Lever Travel Adjustment on Isuzu Vehicles
- • Doosan DA30 Dump Truck the ECU Wiring Tier2 -Removal
