Tutorial:

How to use Launch X431 ECU & TCU Programmer to clone Volkswagen MG1CA811 ECU on bench?

Volkswagen ECU Info:

Car model: Skoda Febia 2006-2020

Engine: DFNB 998 67

ECU: MG1CA811 SPC58

Device:

Launch X431 ECU Programmer or Launch X431 X-Prog3 with PC Adapter

Wiring diagram:

Device connection:

Connect X431 ECU programmer to a PC via USB cable

Connect the programmer and PIN 1, 5, 9, 6, 10 of MG1CA811 ECU via the BENCH mode line

Also supply power to the device

(For X431 X-PROG3 PC Adapter, need to connect with Launch GIII key programmer)

ECU Clone steps:

Step 1: Backup Original MG1CA811 ECU EEPROM & FLASH Data

Step 2: Backup New MG1CA811 ECU EEPROM & FLASH Data

Step 3: Write Original MG1CA811 ECU Data to New ECU

In detail…

Step 1: Backup Original MG1CA811 ECU EEPROM & FLASH Data

Open X431 ECU & TCU Programmer software/X-PROG3 PC Adaptor PC Software

Search keyword MG1CA811 to quickly find the ECU model

Enter the main operation page to start the clone process

Connect>> Read EEPROM data>> Read FLASH data>> Disconnect

Save the data after reading separately

Step 2: Backup New MG1CA811 ECU EEPROM & FLASH Data

Connect X-431 ECU & TCU Programmer/X431 PC Adapter to a new MG1CA811 ECU

Repeat the same steps as step 1 to connect ECU, read and save new EEPROM and Flash data in sequence

Step 3: Write Original MG1CA811 ECU Data to New ECU

Select the EEPROM and Flash data of the original MG1CA811 ECU and write them into the new one respectively.

Disconnect after data writing is completed.

Done!

In addition, Xhorse Multi-Prog Programmer, CG FC200 also can clone Bosch MG1CA811 Engine computer on bench.

Check the related posts below.

Xhorse Multi-Prog Review: More Powerful Than VVDI Prog

CG FC200 ECU Programmer V1.0.9.0 Software Update and Free Download

UK Professional OBD2 Tools Online Shop